2014 JADAIR CT-352EA-M Washing Equipment For Sale

  • Price
  • $443,320 USD
  • Description
  • MASTER SETTLER/CLARIFIER SYSTEM
  • Inventory ID
  • E00041366
  • Serial
  • C0314-1
(800) 437-2924
Machine Location:
View Google Map
General Equipment & Supplies, Inc.
4300 Main Ave
Fargo, North Dakota 58103

Details

  • Inventory ID: E00041366
  • Status: On Yard
  • Make: JADAIR
  • Model: CT-352EA-M
  • Year: 2014
  • Serial#: C0314-1

Equipment Text

  • MODEL CT-352EA-M MASTER SETTLER/CLARIFIER MODULE 1 200 GPM NOMINAL FLOW
  • WITH TWO PARALLEL FLOW STAGES. THIS MODULE PROVIDES CONTROL AND THE HYDRAULIC
  • POWER SOURCE FOR ITSELF AND THE REMOTE AT-022B-R MODULE.
  • LIMITATIONS:
  • MAXIMUM PERCENTAGE OF SOLIDS BY VOLUME AFTER POLYMER TREATMENT IS UP TO 18%.
  • FEED MATERIAL TO SETTLER/CLARIFIER MUST BE 80 MESH AND FINER.
  • THE PADDLE CONVEYORS ARE HYDRAULICALLY DRIVEN THROUGH A DIRECTLY CONNECTED
  • PLANETARY SPEED REDUCER WHICH IS COUPLED TO THE DRIVE SHAFT WITH ROLLER CHAIN SO
  • AS TO DEVELOP THE FINAL SLOW SPEED AND HIGH TORQUE. BOTH PADDLE CONVEYORS ARE
  • HIGH CAPACITY UTILIZING PROPRIETARY HIGH WEAR RESISTANT CHAIN AND SPECIAL RUBBER
  • WEARING SURFACE SCOOP SHAPED PADDLES. EACH CONVEYOR S DRIVE HAS TWO MANUALLY
  • ADJUSTABLE PRESET SPEEDS FOR SELECTION OF SLOW FAST OR THEIR COMBINED HIGH
  • SPEED WITH PRESSURE TRANSDUCER INPUTS TO THE CONTROLLER.
  • THE SYSTEM INCLUDES HYDRAULIC CONTROLS SOLID STATE LOGIC CONTROLLER
  • INCORPORATING AUTOMATIC AND PROGRAMMABLE CYCLES AND HYDRAULIC PRESSURE
  • TRANSDUCER LOAD SENSING ON/OFF CONTROL OF THE CONVEYORS. THERE IS AN LCD AND
  • MEMBRANE KEYPAD OPERATOR INTERFACE UNIT. MOST ELECTRICAL CONTROLS ARE TOUCH
  • SAFE INCLUDING MOTOR CONTROLS. LOGIC CONTROLS OPERATE AT 24 VOLTS DC AND THERE
  • IS A MAIN DISCONNECT SWITCH AT THE CONTROL BOX PLUS AN EMERGENCY-STOP THERE
  • AND ON THE CATWALK. A HYDRAULIC FLUID LOW LEVEL ALARM AND A MAKE-UP WATER
  • LIQUIDLEVEL CONTROL ARE INCLUDED. SPARE SIZE #2 STARTER FOR MAKUP WATER PUMP.
  • A 15 HP ELECTRIC MOTOR WITH A 1.25 SF IS DIRECT COUPLED TO THE HYDRAULIC PUMP;
  • THE COMBINATION IS SUPPORTED BY ISOLATION MOUNTS; THERE IS ALSO AN ELECTRIC
  • MOTOR OF 3HP. THE HYDROSTATIC DRIVE SYSTEM PROVIDES POWER FOR ALL PADDLE
  • CONVEYOR DRIVES AND ROTATING MIXERS. IT WILL RUN PERIODICALLY DURING
  • NON-PRODUCTION HOURS. SYSTEM TOTAL POWER REQUIRED TO BE
  • CONNECTED TO THE MAIN DISCONNECT SWITCH IN THECONTROL BOX BY BUYER 38 RUNNING
  • AMPS OR 44 AMPS INCLUDING THE SERVICE FACTOR OF THE COMPONENTS 460 VOLTS 3N
  • 60 HZ. ALL MACHINE WIRING IS INCLUDED.
  • POLYMER SOLUTION IS SOURCED FROM THE POLYMER PREPARATION AND STORAGE MODULE
  • DESCRIBEDBELOW. ALSO INCLUDED ARE A MOTIONLESS FLASH MIXER ONE POLYMER
  • ADDITION METERING PUMP SYSTEM (1 HP) LIQUID LEVEL CONTROL HEAVY DUTY SCAVENGER
  • PUMP STAIRWAY YELLOW CATWALKS & RAILINGS LOCKOUTS LIGHTS AND 115 VOLT 15AMPS
  • 60 HZ UTILITY POWER.
  • THE ENTIRE TANK PORTION IS CONSTRUCTED WITH BLASTED STEEL AND ALL SEAMS ARE
  • WELDED INSIDE AND OUTSIDE. MACHINE IS CHEMICALLY WASHED PRIOR TO PAINTING. THE
  • PRIMER IS A HIGH SOLIDS EPOXY TYPE AND THE FINISHED PAINT IS TWO-PART HIGH GLOSS
  • POLYURETHANE.
  • NO ON-SITE WELDING OR ELECTRICAL WORK IS REQUIRED OTHER THAN TO CONNECT THE
  • THREE PHASE POWER TO THE MAIN DISCONNECT IN THE CONTROL PANEL. DIRTY WATER
  • INPUT IS FLANGE CONNECTED (8") AND CLARIFIED WATER OUTPUT IS BY GRAVITY VIA ONE
  • OR TWO 10" NPT THREADED COUPLINGS. CATWALKS WHICH ARE NOT ALREADY MOUNTED
  • RAILINGS ETC ARE BOLT IN PLACE. EVERYTHING HAS BEEN ASSEMBLED AND TEST RUN AT
  • THE FACTORY.
  • (1) - MODEL AT-022B-R REMOTE POLYMER PREPARATION/STORAGE MODULE.
  • CAPACITY IS 900 GALLON MIXING WITH ADDITIONAL 1 200 GALLON STORAGE CAPACITY AND
  • INCLUDES AUTOMATIC POLYMER TRANSFER FROM MIX TANK TO STORAGE TANK. THIS MODULE
  • PROVIDES POLYMER SOLUTION FOR THE CT-352 MODULE. MODULE USES HYDRAULIC AND
  • ELECTRICAL POWER FROM THE ASSOCIATED MASTER MODULE. INCLUDES ONE ROTATING
  • MIXER POLYMER TRANSFER PUMP (3 HP INCLUDED IN TOTAL POWER SPECIFIED FOR MASTER
  • MODULE) MANUAL AND AUTOMATIC VALVES SCREEN FILTERS SEMI-AUTOMATICEDUCTOR
  • SYSTEM POLYMER STORAGE CABINET LIQUID LEVEL SENSORS PARTIAL ROOF CATWALKS
  • AND ELECTRICAL AND HYDRAULIC INTERCONNECTIONS TO MASTER MODULE. TANKS
  • INTERIORS ARE SAND BLASTED AND PAINTED WITH EPOXY PAINT. WIRE INTERCONNECTIONS
  • TO THE MASTER MODULE ARE PRE-ASSEMBLED FOR EASY REATTACHMENT AT INSTALLATION
  • LOCATION. HYDRAULIC HOSE INTERCONNECTIONS ARE QUICK CONNECTING TYPE BETWEEN
  • MODULES. ACCESS FROM COMMON CATWALK IS PROVIDED.
  • ALL MODULES HAVE LIFTING EYES SO THEY CAN BE SET IN PLACE ON A LEVEL FOUNDATION
  • CAPABLE OF SUPPORTING THE OPERATING WEIGHT. SELLER WILL PROVIDE GENERAL
  • INSTALLATION DRAWINGS.
  • CONCRETE SLAB AND FINES CONTAINMENT AREA DRAWINGS WILL BE PROVIDED. SLAB AND
  • CONTAINMENT AREA NOT INCLUDED FINES FEED PUMP IF REQUIRED NOT INCLUDED. A
  • STEEL SLIDER PLATE TO BE PROVIDED BY END USER TO PROMOTE POLYMER CHAIN RETENTION
  • FOR OPTIMIZED DEWATERING AFTER DISCHARGE FROM MACHINE.
  • *24 HOUR 480V POWER REQUIRED
  • - PAINTED: CAT YELLOW
  • WATER TESTING FOR POLYMER SELECTION IS REQUIRED.
  • AN ONSITE ENGINEERING CONFERENCE WILL BE SCHEDULED AS REQUESTED AFTER ORDER
  • PLACEMENT WITH JADAIR FACTORY. FACTORY STARTUP AND TRAINING NOT INCLUDED AND
  • WILL BE PROVIDED BYJADAIR FOR ADDITIONAL CHARGE.
  • FRESH WATER TANK (APPROX 5000 GALLONS) INCLUDED. PLUMBING NOT INCLUDED.
  • ONSITE ASSEMBLY BY OTHERS INSTALLATION BY OTHERS.
  • UNIT IS A DEMO UNIT. SOLD AS IS WHERE IS NO WARRANTY.

Make An Offer

INTERESTED IN THIS MACHINE? SEND US A MESSAGE.

Fields with asterisks* are required.

Send to a Friend

Fields with asterisks* are required.