Find that New or Used piece of equipment you've been looking for!

Features
MAIN TANK
– 1/4” (sides & bottom) and 3/8” (rear end plate) welded
plate steel construction
– Integral rising current manifold with 4” inlet
– Long narrow tub
– Full width overflow weir
– Overflow flume with 6” dia. outlet
SPIRAL ASSEMBLY
– Spiral pipe - heavy wall 12” dia.
– Double pitch, combination flight/paddle configuration
(one right hand & one left hand)
– Standard configuration - Four (4) bolt-on paddle
assemblies (two (2) replaceable two piece Ni-Hard
paddle tips per assembly) and two (2) bolt-on flight
assemblies; balance of the spiral assembly is welded
solid flights with bolt-on AR steel inner and Ni-Hard outer
wear shoes (see reverse side for additional information
and optional configurations)
– Greaseable, externally mounted Dodge Imperial E tail
end flange bearing
– Greaseable Dodge Type E pillow block head end bearing
– Lower end seal - chrome plated stainless steel wear
sleeve, water tight bellows type rubber seal and
secondary grease seal
DRIVE ASSEMBLY (one drive assembly per spiral)
– High efficiency v-belt drive assembly
– 25-HP TEFC motor
– Dodge TA-II double reduction shaft mount reducer
DISCHARGE CHUTE (optional)
– Tapered discharge chute set at 45° angle to grade
SUPPORT ASSEMBLY (optional)
– Head-end support weldment with 6” wide flange
columns
PHYSICAL/OPERATING CHARACTERISTICS
– Feed Material Size - Typically minus 2-1/2” x +3/8”
– Angle of Operation - 15°
– Capacity - Up to 350 TPH
– Shaft Speed - 30 rpm
– Water Requirements - Up to 900 gpm
– Operational Dim. - 23’9” long x 7’7” wide x 10’11” high
– Loads - Approx. Dead Load = 17,000 lbs.
Approx. Live Load = 37,000 lbs.
Approx. Total Load = 54,000 lbs.
Specifications
Model |
Spiral Diameter |
Capacity* |
Water Requirements |
6036-19T |
36 / 914 |
300 - 350 |
700 - 900 |
0% Financing for 48 Months
Check out our financing special offering 0% for 48 months!